Dräger 8000 NC - Using Skin Temperature Control.23

Operation
Using skin temperature control
When there is a "skin temperature control" module installed
and it is in operation, the "air temperature control" mode
can be switched on again:
1 Press 0 key,
2 green Control LED is lit.
The "air temperature control" mode is re-activated.
The set value for air temperature will be the last value
determined by the system.
Using skin temperature control
When the skin temperature control option is installed.
Do not use on babies in shock as their skin temperature
is well below normal. Using skin temperature control
would increase the temperature of the incubator too
much.
To control air temperature, see p. 20.
Core temperature must be measured regularly.
23