Dräger 8000 NC - Page 27

Operation
Using skin temperature control
Alarms
Alarms
For deviations greater than ±0.5 °C between set value
and actual value of skin temperature:
1 Red Alarm LED and
2 Red ±0.5 °C LED flash,
3 display flashes and intermittent tone commences.
The intermittent tone can be suppressed for 10 minutes:
4 Press ® key.
5 Yellow $ LED and red Alarm LED are lit.
When measured value is within ±0.5 °C of the set value
again,
2 ±0.5 °C LED and
1 red Alarm LED go out.
intermittent tone ceases.
5 Yellow (&. LED goes out.
If the sensor plug is disconnected or sensor is faulty:
6 Display of 3 dashes in centre of display.
After 15 seconds:
• Intermittent tone commences.
6 Display of 3 flashing dashes in centre of display.
7 Red Alarm LED and
8 red Sensor alarm LED are lit.
Then:
• Connect sensor without delay or replace skin
temperature sensor.
°C HAUT/SKIN/PEAU/PIEL °C LUFT/AIR
o °
< \
'
_J
o o
V _> < _J
• 7
o
o
o
□
□
The intermittent tone can be suppressed for 10 minutes:
• Press @ key, yellow & LED and
red Alarm LED are lit.
27