Dräger 8000 NC - Page 36

Care
Cleaning/disinfecting/sterilizing
Canopy, inside and outside
Inner wail folded down
Mattress
Bed / Bed extension
Support brackets
Base plate
Trough
Incubator housing, inside and outside:
• Remove obvious soiling with disposable cloth and
detergent.
• Wipe-disinfect surfaces.
• Allow time for the disinfection process, then wipe the
surfaces again with a clean, damp cloth and dry.
Fan
Seals
Hose seals
Water hose
Water container/Bottle holder:
• Wash with detergent and rinse with clean water.
• Disinfect in bath. Allow time for the disinfection
process, then rinse with clear water and dry;
or
• sterilize at 120 °C (glove programme).
Use recommended cleaning and disinfecting agents only.
If other agents, such as alcohol for instance, are used
there is a risk of tension cracks in the Acrylic and
Makrolon.
Do not use UV-radiation on the incubator. This may cause
cracks in the acrylic parts.
36