Dräger Infinity Central Station - Page 32

© 2014 Draeger Medic al , Inc .
INFINITY CENTRAL STATION & M300 QUICK REFERENCE GUIDE
| 32
THIS GUIDE IS INTENDED FOR REFERENCE ONLY. REFER TO INSTRUCTIONS FOR USE MANUAL.ADDITIONAL INFORMATION
appears.
8. Select
Yes in the confirmation popup to start the data transfer.
The message
Transfer completed appears after the data have
been transferred.
TRANSFER M300 TO DRÄGER BEDSIDE MONITOR
1. Select the M300 parameter bo x at the ICS whose data you wish
to
transfer to the bedside monitor.
2. Put the M300
(containing the data you want to transfer) into
standby mode. Only patients in standby mode are candidates for
transfer.
3. Go to the
destination bedside monitor and start the data trans-
fer.
4. Select desired device to be transferred (transfer button location
varies by
de v ice).