Dräger Infinity Central Station - Spo 2 Monitoring

© 2014 Draeger Medic al , Inc .
INFINITY CENTRAL STATION & M300 QUICK REFERENCE GUIDE
| 26
THIS GUIDE IS INTENDED FOR REFERENCE ONLY. REFER TO INSTRUCTIONS FOR USE MANUAL.ADDITIONAL INFORMATION
TO TURN SpO
2
MONITORING ON/OFF FOR A M300 PATIENT
1. Open the BedView page by selecting the viewport of the te-
lemetry patient on the ICS Main screen.
2. Select the Telemetry/ Parameters... button on the Bedview
menu bar.
3. Select the Layout/Parameters tab.
4. Select the SpO
2
tab.
5. Select On or Off button to turn SpO
2
monitoring on or off.
6. Select Apply.
7. Check the Layout tab to make sure SpO
2
is assigned to a chan-
nel. If not assigned select SpO
2
+ PLS in desired channel in the
parameter column and select Apply.