Supplement for Infinity CentralStation Wide
16 Supplement
– Infinity CentralStation Wide – VG2.1.2
– Under Parameter order select a pre-configured template or select Follow bed (refers to the order
of the waveform and parameters as displayed and sent by the bedside monitor).
– Under Bottom, select Waveform or Parameters. Selecting Parameters displays
a total of 3
parameter boxes in the lower channel for Split screen, or a total of 4 parameter boxes for Full
screen.
7 Select Apply at the bottom of the screen to save the current configuration, or select Undo to cancel
changes.
8 Repeat steps 3 to 7 to customize Layout 2, Layout 3, and Layout 4.
9 To activate a layout that you created, select Layouts... from the main menu bar.
10 In the Layouts dialog, select the desired layout, and click Apply.
Password protection
To allow access to the Main screen layout tab without a password, perform the following steps.
1 Select System setup... on the main menu bar.
2 Select the Biomed tab.
3 Select the Passwords tab.
4 Select Off next to Main screen layout password.
5 Select Apply.
Customized viewport layout
1 Select Main screen on the main menu bar.
2 Select the menu icon for the patient bed that you want to customize
3 Select Change patient parameters to display the Customize layout for: dialog for the selected bed.
Beds Parameters
1-2 Up to 8
3-4 Up to 4
5-6 Up to 3
7-8 Up to 2
NOTE
The triangle indicates that the patient
viewport is customized.
To Next Page
Loading...
