Instructions for use – Infinity Acute Care System – Monitoring Applications VG6.n 483
System configuration
To configure an IT application tab
In the following steps, the letters in parentheses
correspond to the diagram for the IT setup page
(see page 482).
1 Access the IT setup page (see page 470).
2 Select the tab of the IT application you wish to
configure.
3 Select the following buttons to configure the
corresponding settings:
– Select the symbol next to the Name
menu selection (C) to activate a keyboard
for changing the name of the IT label (the
name of the actual tab in the IT setup page
does not change).
– Select the symbol next to the URL menu
selection (D) to activate a keyboard for
entering the URL.
– Select the Full Trust on or off button (E) to
select the security setting for this website.
– Select the Block Popups on or off button
(F) to allow or prevent popups from
appearing on this website.
4 Select the Tab visible on or off button (G) to
display or hide the tab.
Once an IT application is correctly set up, the
website is accessible under the corresponding IT
tab (for more information, see "Accessing an IT tab"
on page 505).
CAUTION
The URL address shows a pre-configured string.
Do not change any portion of the string except for
the <server name> to preserve the correct infor-
mation.
NOTE
IT tabs appear grayed out and are therefore not
selectable while the application is loading. A tab
may also appear grayed out the first time an ap-
plication is turned on.
To Next Page
Loading...
