19
Identifying Alarms
Battery pre-alarm
Acknowledging the pre-alarm:
● Press the key. Only the audible alarm and the vibration alarm are switched off.
— The battery still lasts approx. 20 minutes after the first battery pre-alarm.
Battery main alarm
The battery main alarm cannot be acknowledged or cancelled:
— The device is automatically switched off again after 10 seconds.
— Before the device is switched off, the visual, audible and vibration alarms are activated for
a short time.
Device alarm
— The device or one or several sensor channels are not ready for operation.
— For remedies, refer to page 23 to page 25.
● If necessary, commission the Dräger Safety Service Center to eliminate the error.
End of operation
Only in the case of X-am 1700.
A warning period starts before the end of the operating time.
— After switching on the device, the special symbol » « (for warning) is displayed.
Acknowledging the end of operation warning:
● Press the key. The device will continue to operate until the operating time has elapsed.
— When the operating time has elapsed, the text »d0« flashes. The device cannot be swit-
ched on anymore.
The alarm is indicated by an intermittent alarm message:
Flashing special symbol »« on the right side of the display:
The alarm is indicated by an intermittent alarm message:
Flashing special symbol »« on the right side of the display:
Intermittent alarm message:
Special symbol » « on the right side of the display:
OK
To Next Page
Loading...
Need help?
General
