www.dragino.com
LHT52 Temperature & Humidity sensor 15 / 40
2.5 Show data on Datacake
Datacake IoT platform provides a human friendly interface to show the sensor data in charts,
once we have sensor data in TTN V3, we can use Datacake to connect to TTN V3 and see the data
in Datacake. Below are the steps:
Step 1: Be sure that your device is programmed and properly connected to the LoRaWAN
network.
Step 2: Configure your Application to forward data to Datacake you will need to add integration.
Go to TTN V3 Console --> Applications --> Integrations --> Add Integrations.
1.Add Datacake:
2.Select default key as Access Key:
3.In Datacake console (https://datacake.co/) , add LHT52:
Please refer to the figure below
To Next Page
Loading...
