www.dragino.com
LPS8 LoRaWAN Gateway User Manual --- Update:2019-Oct-26 18 / 36
4.4 Add a LoRaWAN End Device
This section shows how to add a LoRaWAN End device to a LoRaWAN network and see the data
from TTN web site.
We use LT-33222-L IO Controller as a reference device - the setup for other LoRaWAN devices will
be similar.
Step 1: Create a Device definition in TTN with the OTAA keys from the example LT-33222-L IO
Controller device.
Three codes are required to define the device in TTN:
DEV EUI - Unique ID code for a particular device.
APP EUI - ID code for an Application defined in TTN.
APP Key - Unique key to secure communications with a particular device.
A set of these codes are stored in each device by the manufacturer as the default codes for that
particular device. Each device is shipped with a sticker with the default Device EUI as shown
below.
Note: You may be able to change these codes in a device by using a configuration facility on the
device e.g. the LT-33222 uses a serial port access and a series of AT commands. Changing the
codes may be necessary in the case where you have to use codes assigned by a LoRa WAN server.
For the TTN server, you can use the codes set in the device as in the following example.
To Next Page
Loading...
Need help?
General
