Need help?Do you have a question about the Dragino LG01 LoRa and is the answer not in the manual?
General| Connectivity | Ethernet, Wi-Fi |
|---|---|
| Wi-Fi | 802.11 b/g/n |
| Max Output Power | 20 dBm |
| LoRa Frequency | 433/868/915 MHz |
| Operating Temperature | -20°C to 70°C |
| LoRa Module | SX1276 |
| Ethernet | 10/100Mbps |
| Frequency Band | 433MHz / 868MHz / 915MHz |
| Processor | MT7628 |
Details the hardware and software specifications of the LG01 LoRa Gateway.
Guides users on how to initially connect to and configure the LG01 via its default WiFi AP.
Explains how to program the LG01's microcontroller using the Arduino IDE.
Steps to download, install, and configure the Arduino IDE for Dragino boards.
Instructions on uploading a simple sketch to the LG01's microcontroller.
Instructions for uploading the LoRa Server sketch to the LG01.
Instructions for uploading the LoRa Client sketch to a compatible device.
Configuration steps for setting up the LG01 as a mesh gateway node.
Configuration steps for setting up the LG01 as a mesh client node.
How to access the LG01's Linux console using SSH and the PuTTY tool.
Using WinSCP to edit and transfer files between a PC and the LG01 via SFTP.
Procedures for resetting network settings or the entire device to factory defaults.
Instructions for upgrading the LG01 firmware using the web interface.
Steps for upgrading the LG01 firmware via the Linux command line using SCP.
Guides on sending data from LoRa nodes to an IoT server.
To Next Page
