Dragino LG01 LoRa - Upload a sketch in the MCU

www.dragino.com
LoRa Gateway User Manual ---Update:2017-02-21 12 / 44
2.2.2 Upload a sketch in the MCU
For the very start, we can try to upload a simple sketch to the MCU and see how it works.
 Make sure your computer and the LG01 is in the same network, if you already connect to
the LG01 WiFi SSID, then both devices are in the same WiFi network. In the IDE, select the
correct port as below screenshot.
 Select the example from IDE --> File --> Examples --> Dragino --> Basic --> Blink
Click Upload to upload the sketch to LG01, the LG01 may ask you password to upload, if so,
type the password of LG01.