Draytek VigorAP 912C User Manual

10
4
4
.
.
3
3
.
.
2
2
C
C
o
o
n
n
n
n
e
e
c
c
t
t
e
e
d
d
a
a
s
s
a
a
n
n
A
A
c
c
c
c
e
e
s
s
s
s
P
P
o
o
i
i
n
n
t
t
As an access point, the VigorAP 912C needs to be connected to a router and
configured in AP (Access Point) / Range Extender mode.

Install the VigorAP on to the ceiling.

Use a twisted-pair cable with RJ-45 plugs at both ends, and plug into
Ethernet device (e.g., Vigor router) and Ethernet port of VigorAP.
Note
If the VigorAP is connected to a router’s network, connect
your PC to that network and ensure your PC’s IP address is
assigned dynamically.
If connected directly to the VigorAP with no other network,
configure your PC with an IP address in the 192.168.1.x
range.
⚫ If there is no DHCP server on the network, the VigorAP
912C will have an IP address of 192.168.1.2.
⚫ If there is DHCP available on the network, the VigorAP
912C will receive its IP address via the DHCP server.
⚫ Connect to the VigorAP’s default wireless LAN SSID using
the QR code, the web interface can then be accessed
from http://vigorap.com.

Draytek VigorAP 912C Specifications

General

Brand	Draytek
Model	VigorAP 912C
Category	Wireless Access Point
Language	English