2
2
2
.
.
P
P
a
a
n
n
e
e
l
l
E
E
x
x
p
p
l
l
a
a
n
n
a
a
t
t
i
i
o
o
n
n
LED Status Explanation
On The syst em is in boot -loader mode.
Off The syst em is not ready or f ails.
Blue LED
Blinking The syst em is in AP mode and work normally.
Green LED Blinking The syst em is in Mesh mode or Range Ext ender mode
and works normally.
Orange LED Blinking The syst em is in TFTP mode.
Off Of f VigorAP is t urned of f or not f unct ioning.
Interface Explanation
Et hernet Port Connect s t o LAN or rout er.
Support s PoE power & Gigabit (1000BaseT).
Power Jack (DC IN) Connect er for a power adapt er.
Hole Explanation
Fact ory Reset Rest ores t he unit back t o f act ory default set t ings.
To use, insert a small it em such as an unbent
paperclip int o t he hole. You will feel t he but t on
inside depress gent ly. Hold it for 5 seconds.
The VigorAP will rest art wit h t he fact ory default
conf igurat ion and t he LED will blink blue.
Note
For t he sake of securit y, make t he accessory kit away from
children.
Remove t he prot ect ive f ilm f rom t he access point before use
t o ensure vent ilat ion.
LED
Factory
Reset
Ethernet Port
Power Jack (DC IN)
To Next Page
Loading...
Need help?
General
