Dreame H12 Core Manual

55
56
EN
EN
Note: Do not add any liquids other than the officially-approved cleaner. The cleaner can be
available on the official online store.
How to Use
Filling the Clean Water Tank
Press the Clean Water
fill the tank with clean
Tank release button to remove the tank. Open the tank cover
and water.
Adding Cleaning
For better cleaning bottle
cap is recommended to add 10 ml detergent with the
performance, it into the full Clean Water Tank, then shake gently and evenly for use.
Fluid
10 ml
How to Use
Starting Cleaning
Gently step on the brush cover and recline the appliance backwards. Press the power
switch to start/stop operating.
Switching Modes
The appliance is powered on by default in Auto mode, you can switch to the suction
mode according to actual needs.
Auto Mode: The appliance will adjust the
suction power according to the stains on
the ground.
Suction Mode: If the suction mode is
selected, the appliance will vacuum water
only and the brush roller will not be
dampened. No water is coming out of the
Clean Water Tank.
Note:
• Do not vacuum any foamy liquids.
• If the appliance is in the upright position while working, the current task will be suspended.
• The appliance is suitable for cleaning floors, marble, tiles and other hard surfaces.
• Do not recline the appliance backwards more than 140° to prevent the appliance from leaking
water.
• When the appliance isin operation,do not lift
it off the ground, move it, tilt itorlay it flat.Doing so
may cause the usedwatertoflow into the motor.
＜40°＜
140°

Dreame H12 Core Specifications

General

Battery Capacity	4000 mAh
Clean Water Tank Capacity	900 ml
Dirty Water Tank Capacity	500 ml
Display	LED
Self-Cleaning	Yes
Power	200 W
Type	Cordless Wet and Dry Vacuum Cleaner
Dustbin Capacity	Not applicable
Cleaning Modes	Auto, Max
Run Time	35 minutes
Charging Time	4-5 hours