Dreame H12 Core Manual

59
60
EN
EN
Cleaning the Brush Roller
1. Press the brush roller release
handle of the brush button and the
roller will pop
take out the
out.
brush
Pull the handle
to roller.
2. Clear any hair and debris caught on
the brush roller with the provided
cleaning brush. Rinse the brush roller
with clean water and dry it completely.
3. Wipe the suction inlet with a dry
dishcloth or wet tissue.
the brush roller. You should 4. Re-install
hear a click.
Warning: To reduce the risk of electric shock or injury, do not rinse theroller brush
assembly
with water!
Note: Clean as needed. Replacing the filter every 3 to 6 months is recommended.
Care & Maintenance
Water Tank release1. Press the Used
button to remove
the tank.
& Care Maintenance
Cleaning the Used Water Tank and the Filter
3. Rinse the Used Water Tank and the
tank cover with clean water. Clean the
tank by the provided cleaning brush.
2. Take out the filter from the Used Water
Tank cover. Remove the tank cover and
pour out the used water.
4. Re-install the filter and the Used Water
Tank cover. Then re-install the Used
Water Tank until you hear click. a
Used Water
Tank Cover
Filter
Click

Dreame H12 Core Specifications

General

Battery Capacity	4000 mAh
Clean Water Tank Capacity	900 ml
Dirty Water Tank Capacity	500 ml
Display	LED
Self-Cleaning	Yes
Power	200 W
Type	Cordless Wet and Dry Vacuum Cleaner
Dustbin Capacity	Not applicable
Cleaning Modes	Auto, Max
Run Time	35 minutes
Charging Time	4-5 hours