Dreame H12 Core - Specifications

65 66
EN
EN
Specifications
Vacuum
Model HHR22B Charging Time Approx. 5 hours
Rated Voltage 21.6 V
Charging Voltage 26 V
Rated Power 200 W Rated Capacity 2300 mAh
Nominal Capacity 2500 mAh
Used Water
Tank Capacity
500 mL
Clean Water
Tank Capacity
900 mL
Power Adapter
Model
YLS0251B-E260090
Average Active
Efficiency
87.28%
Input
100-240 V ~ 50/60 Hz
0.8 A Max
Efficiency at Low
Load (10%)
79.74%
Output 26 V
0.9 A
No-Load Power
Consumption
0.08 W
Battery Disposal and Removal
The built-in lithium-ion battery contains substances that are hazardous to the
environment. Before disposing of the battery
, make sure the battery is removed by
qualified technicians and discarded at an appropriate recycling facility.
— thebatterymustberemovedfromtheappliancebeforeitisscrapped;
— theappliancemustbedisconnectedfromthesupplymainswhenremovingthe
battery;
— thebatteryistobedisposedofsafely.
CAUTION:
• Before removing the battery, disconnect the power and run out the battery as much
as possible.
• Unneeded batteries should be discarded at an appropriate recycling facility.
• Do not expose to high temperature environment to avoid risks of explosion.
• Under abusive conditions, liquid may be ejected from the battery. If contact occurs,
flush with water and seek medical help.
1. Removethe
handle,decorativeringinthemiddleofthe applianceandscrewplugs.
2. Useapropertooltoremovethescrewsonthebackofthe appliance,andthen
remove the back cover.
3. Removethescrewsonthebatterycovertoopenthebatterycover.
4. UnplugtheterminalsbetweenthebatteryandPCBboardtoremovethebattery.
Removal Guide