Dreame H12 Core Manual

57
58
EN
EN
One-Click Self-Cleaning
1. Place the appliance back onto the base while you finish cleaning.
2. Briefly press the self-cleaning button on the top of the handle
to start/stop self-cleaning.
3. Empty the Used Water Tank while self-cleaning is completed.
Note: The self-cleaning mode can be enabled only
when the appliance is being charged and the battery
level is more than 20%.
Care & Maintenance
Tips:
• Turn off the appliance before maintenance. Do not touch the power switch.
• Replace parts if needed. The parts must be replaced by those available from the
manufacturer or its service agent.
• If the appliance is not used for an extended period, fully charge it, unplug

the power
plug, and store the appliance in a cool, low-humidity environment away from direct
sunlight. To avoid over-discharge of the battery
, charge the appliance at least once
every 3 months.
Care & Maintenance
Cleaning the Brush Cover
roller cover release buttonsinwardson both sides to remove the
1. Press the brush
brush roller cover.
with a dishcloth. Dry it 2. The brush cover can be rinsed with clean water or wiped
completely before reuse.
Click

Dreame H12 Core Specifications

General

Battery Capacity	4000 mAh
Clean Water Tank Capacity	900 ml
Dirty Water Tank Capacity	500 ml
Display	LED
Self-Cleaning	Yes
Power	200 W
Type	Cordless Wet and Dry Vacuum Cleaner
Dustbin Capacity	Not applicable
Cleaning Modes	Auto, Max
Run Time	35 minutes
Charging Time	4-5 hours