11
Assembly and Disassembly of Handle
Insert the end of the handle vertically into the port on the top of the vacuum as
indicated until you hear a click.
Note: To disassemble, press the contacts in the hole on the back of the appliance with
the appropriate tool and pull the handle upward at the same time.
Charging
1. Place the charging base against a wall on level ground and connect it to a power
source. Fully charge the appliance before first use.
2. Place the appliance on the charging base. When the voice prompt “Charging
Started” is displayed, the appliance activates the charging mode. When charging,
the number on the display screen represents the current battery level as a
percentage. When the number reaches 100, the battery is fully charged.
To Next Page
Loading...
