10 11
Note: When the vacuum is working, neither move it o the ground nor lay it at. Otherwise, the dirty
water may ow into the motor.
Do not recline the vacuum backwards more than 140° to prevent the vacuum from
leaking water.
Do not use to vacuum any foamy liquids.
＜40°＜140°
Auto Mode / Suction Mode
The vacuum is powered on by default in Auto mode, you can switch to the Suction mode
based on your needs.
Auto Mode: The vacuum can adjust its suction power depending on dierent situations.
Suction Mode: The vacuum can clean the water stains on the oor.
How to Use
Starting Cleaning
Briey press the button to power on, and the vacuum will start cleaning. The vacuum
comes with an upright/reclining switch. Please gently step on the brush cover and
recline the vacuum backwards to start operating. If the vacuum is in the upright position
while working, the current task will be suspended.
1
2
How to Use
Filling the Clean Water Tank
1. Press the clean water tank release
button and pull the tank outwards to
remove it.
2. Remove the cover of the clean water
tank and ll the tank with clean water.
3. Close the tank cover tightly. 4. Install the clean water tank and ensure
it clicks into place.
Click
To Next Page
Loading...
Need help?
General
