12 13
Care & Maintenance
Cleaning the Brush Roller Cover
1. Press the brush roller cover release
buttons at both ends inward to remove
the cover
2. Rinse the cover with clean water or
wipe it with a cloth.
* Clean it as needed.
3. Dry the cover completely before use. 4. Re-install the cover back.
Care & Maintenance
One-Touch Self-Cleaning
1. After the vacuum completes the cleaning task,
place it back onto the base and make sure that
the water in the clean water tank is sucient for
self-cleaning.
2. Briey press the self-cleaning button on the top
of the handle, the self-cleaning indicator will
light up, and the vacuum will start self-cleaning.
3. After the self-cleaning ends, the vacuum
continues charging its battery.
* The self-cleaning function can be enabled only when the vacuum is being charged and the battery
level is more than 15%.
Tips:
1. Turn o the vacuum before care and maintenance.
2. Replace parts if needed. The parts must be replaced by those available from the
manufacturer or its service agent.
3. If the vacuum is not used for an extended period, fully charge it, unplug the power
adapter, and store the vacuum in a cool, low-humidity environment away from direct
sunlight. To avoid over-discharge of the battery, charge the vacuum at least once
every 3 months.
Note: After the vacuum completes self-cleaning, clean theusedwater tankpromptly. If some stains
are left on the charging base, clean the base.
To Next Page
Loading...
Need help?
General
