9
Starting Cleaning
Gently step on the brush cover and tilt the machine backwards. Press the on/off
switch to start/stop the machine.
Note:
To prevent damage, do not use the vacuum on foamy liquids.
The appliance is designed for cleaning hard surfaces, such as floors, marble, and
tiles.
To avoid water leakage, do not recline the appliance backwards more than 140°.
Do not move or tilt the appliance while it is in operation, as this may cause used
water to flow into the motor.
Switching Modes
The unit is switched on in Auto mode by default, you can switch to Suction mode if
required.
Auto Mode: The appliance will adjust the suction power according to the dirt on
the floor.
Suction Mode: If the suction mode is selected, the appliance will vacuum water
only and the brush roller will not be dampened. No water is coming out of the Clean
Water Tank.
Care and Maintenance
Tips
Before performing any maintenance, ensure that the appliance is turned off.
When replacing parts, only use those available from the manufacturer or its service
agent.
f the appliance will not be used for an extended period, fully charge it, unplug the
power plug, and store it in a cool, low-humidity environment away from direct
sunlight. To prevent the battery from being over-discharged, it is recommended to
charge the appliance at least once every three months.
One-Click Self-Cleaning
After cleaning, return the appliance to its base and briefly press the self-cleaning
button located on the top of the handle to start or stop the self-cleaning process.
Remember to empty the water tank after the self-cleaning process is complete.
Note: The self-cleaning mode can only be activated when the device is charged to more
than 20%.
To Next Page
Loading...
