Dremel 3D45 User Manual

Touch Screen
17
TOOLS
Tap to access the following individual printer
functions and settings.
NETWORK
Tap to enter Network menu to connect or disconnect
WiFi and Set Proxy.
CONNECT WIFI – Tap to connect to WiFi.
SET PROXY – Tap to set manual proxy.
SET STATIC IP – Tap to setup static IP.
PREHEAT
Tap "Nozzle Temp" to automatically begin
preheating the extruder for building or removing
excess debris. Once your optimal temperature is
achieved, tap "Plate Temp" to begin preheating the
build platform.
PURGE – Once extruder is hot, tap to manually
extrude filament.
DM 2610047405AB 03-18_3D45 3/27/18 9:51 AM Page 17

Dremel 3D45 Specifications

General

Layer Resolution	50 - 300 microns
Filament Diameter	1.75 mm
Nozzle Diameter	0.4 mm
Max Extruder Temperature	280 °C
Max Bed Temperature	100 °C
Technology	Fused Filament Fabrication (FFF)
Heated Bed	Yes
Print Speed	Up to 150 mm/s
Enclosed Print Chamber	Yes
Connectivity	USB, Wi-Fi, Ethernet
Supported Filaments	PLA, Nylon, PETG, ECO-ABS
Printer Dimensions	515 x 406 x 403 mm
Display	Full-color touchscreen
Power Requirements	100 - 240 V, 50/60 Hz