Dremel 3D45 User Manual

Table of Contents
2
Safety Symbols....................................................................................2
General Safety Warnings..................................................................3-5
Additional Safety Warnings..................................................................5
Symbols ...............................................................................................5
Dremel Remote Services.....................................................................5
FCC Compliance .................................................................................6
Information on Intellectual Property .....................................................6
Specifications.......................................................................................7
Resources............................................................................................8
Glossary of Terms.............................................................................8-9
Introduction ........................................................................................10
Kit Contents .......................................................................................10
Unpacking ..........................................................................................11
Getting To Know Your Dremel 3D45.............................................12-13
Touch Screen................................................................................14-20
Initial Setup ........................................................................................21
Dremel Cloud Platform ......................................................................22
Getting Ready to Build..................................................................23-27
Building.........................................................................................28-30
Removing Your Object .......................................................................31
Using the Camera..............................................................................32
Best Practices....................................................................................33
Maintenance .................................................................................33-34
Troubleshooting ............................................................................35-36
Firmware and Open Source Software ...............................................37
Dremel
®
Consumer Limited Warranty ................................................38
Safety Symbols
The definitions below describe the level of severity for each signal word. Please read the
manual and pay attention to these symbols.
!
This is the safety alert symbol. It is used to alert you to potential
personal injury hazards. Obey all safety messages that follow this
symbol to avoid possible injury or death.
DANGER indicates a hazardous situation which, if not avoided, will
result in death or serious injury.
WARNING indicates a hazardous situation which, if not avoided, could
result in death or serious injury.
CAUTION, used with the safety alert symbol, indicates a hazardous
situation which, if not avoided, will result in minor or moderate injury.
DM 2610047405AB 03-18_3D45 3/27/18 9:51 AM Page 2

Dremel 3D45 Specifications

General

Layer Resolution	50 - 300 microns
Filament Diameter	1.75 mm
Nozzle Diameter	0.4 mm
Max Extruder Temperature	280 °C
Max Bed Temperature	100 °C
Technology	Fused Filament Fabrication (FFF)
Heated Bed	Yes
Print Speed	Up to 150 mm/s
Enclosed Print Chamber	Yes
Connectivity	USB, Wi-Fi, Ethernet
Supported Filaments	PLA, Nylon, PETG, ECO-ABS
Printer Dimensions	515 x 406 x 403 mm
Display	Full-color touchscreen
Power Requirements	100 - 240 V, 50/60 Hz