8
LT-2334
POWER OPTIONS
POWER OPTIONS
Your iGo2 POC can be used on the 3 following power sources:
1. Battery Power – Your device must always have a battery installed to
operate. The iGo2 POC will use battery power if no other power source
is present. However, if AC or DC power is connected, the device will
run on that power source thus conserving battery charge level. If the
other power source is disconnected, the device will automatically switch
to battery power. The device will operate for a minimum of 3.5 hours at
a setting of 2 at 20 BPM (breaths per minute) using a new fully charged
battery.
2. AC Power (for use at home or where standard AC power is available) –
Attach the universal AC Power Supply to the concentrator and an AC
power outlet using the AC Power Cord.
3. DC (car charger) Power.
a. START YOUR VEHICLE.
NOTE– DO NOT leave the iGo2 or Power Supply plugged into
the vehicle without the engine running or attempt to start the
vehicle while either is connected to the vehicle. This may drain the
vehicle’s battery.
b. Attach Power Supply to the device and to the vehicle accessory
power port using the DC power cord.
c. Secure the iGo2 POC and Power Supply in your vehicle and make
sure the air inlet and exhaust vents are not blocked.
NOTE– Battery will not charge if plugged into power source less than
13.8V but the device will function correctly.
To Next Page
Loading...
