-9-
2.4 Operation Mode
* OPERATION *
REM/STOP/FOR/JOG
(0.0) FOUT
60.0 [Hz]
Display changes if the operation key is pressed.
REM: Remote operation is selected.
DIR: Operation from the console is selected.
FOR/REV: Forward/reverse selection.
JOG: Jogging
START/STOP: Starting or stopping operation.
Monitor code number, content and data.
2.5 How to protect Data
On completion of adjustment, protect data in order to prevent it from being written or lost by
maloperation, etc..
(1) Remove the cover from the unit. Open the console to the right.
(2) Undo the console. Close the cover.
Safety precaution
Be sure to protect data while the VFC61 is stopped.
3. Automatic Measuring
The exact constants (resistances) of the motor used with inverter should be set in order to run the
inverter properly.
Carry out automatic measuring for the motor only by disconnecting the motor from the load.
Safety precaution
As the voltage is impressed to the motor by automatic measuring, connect the GND terminal of the
motor to ground.
Set switch 4 of SW1 on the control PCB (VFC61) to ON.
Any data cannot be written in the function mode.
VFC61
4
3
2
1
ON
SW1
To Next Page
Loading...