Copyright 2010 Baker Hughes Company.
English–PACE Indicators Instruction Manual | 53
Specification
6.7.2 Screen Calibration
Selects touch screen calibration routine.
6.7.3 Time & Date
Sets instrument clock and date.
6.7.4 Change PIN
Changes the Calibration PIN.
a. Enter the existing PIN.
b. Enter the new PIN.
c. Confirm the new PIN.
Note: Confirmation of the new PIN permanently replaces the old PIN. Record this new PIN and
keep in a safe place. If new PIN is lost it can only be reset by returning the instrument to a Druck
service center. For more information regarding calibration, refer to PACE Calibration Manual
K0450.
6.8 Specification
Refer to the PACE1000 Data Sheet for details.
Note: The Data Sheet is contained in the CD shipped with the product.
6.9 Options
6.9.1 Soft Options
To enable soft options on a PACE instrument, use the following:
1. Touch the top Measure area of the screen.
2. Select Global Setup.
3. Select Calibration.
4. Enter a Calibration PIN 1234.
5. Enter new option key xxxxxxxxxx (10 digits).
6. After entry of this key PACE confirms the options have been enabled.
Note: Hardware options automatically enable post installation.
To Next Page
Loading...
