Conditions to Void Warranty
Thiswarranty appliesonlyto defectsin partsand workmanship relating to normal
use. It doesnot cover:
l damage incurred in shipping orhandling;
l damage caused bydisastersuch as fire, flood, wind, earthquake or light-
ning;
l damage due to causesbeyond the controlof DigitalSecurity Controlssuch
asexcessive voltage, mechanicalshockorwaterdamage;
l damage caused byunauthorized attachment, alterations, modificationsor
foreign objects;
l damage caused byperipherals(unlesssuch peripheralswere supplied by
DigitalSecurityControls);
l defectscaused byfailure to provide a suitable installation environment for
the products;
l damage caused byuse of the productsforpurposesotherthan those for
which itwasdesigned;
l damage fromimpropermaintenance;
l damage arising out of anyotherabuse, mishandling orimproper application
of the products.
Items Not Covered by Warranty
In addition to the itemswhich void the Warranty,the following itemsshall not be
covered byWarranty:(i) freight cost to the repaircentre; (ii) productswhich are not
identified with DSC's productlabel and lot number or serialnumber; (iii)products
disassembled or repaired in such a manner asto adverselyaffect performance or
prevent adequate inspection or testing to verify any warrantyclaim. Accesscards
ortags returned forreplacement under warranty willbe credited or replaced at
DSC'soption. Productsnot covered bythiswarranty, orotherwise out of warranty
due to age, misuse, ordamage shallbe evaluated, and a repairestimate shallbe
provided. No repairworkwill be performed untila valid purchase orderis received
from the Customer and a Return Merchandise Authorisation number (RMA) is
issued byDSC'sCustomerService.
DigitalSecurity Controls’s liability for failure to repair the product under this war-
rantyaftera reasonable number of attemptswillbe limited to a replacement of the
product, asthe exclusive remedyforbreach of warranty. Underno circumstances
shallDigitalSecurityControlsbe liable for anyspecial, incidental, orconsequential
damages based upon breach of warranty, breach of contract, negligence, strict
liability,or any otherlegal theory. Such damagesinclude, but are not limited to,
lossof profits, loss of the product or any associated equipment, cost of capital,
costof substitute or replacement equipment, facilitiesorservices, down time, pur-
chaser’stime, the claimsof third parties, including customers, and injury to prop-
erty. The laws of some jurisdictions limit or do not allow the disclaimer of
consequentialdamages. If the laws of such a jurisdiction apply to anyclaim byor
against DSC, the limitations and disclaimers contained here shall be to the
greatest extent permitted bylaw. Some statesdo not allow the exclusion or lim-
itation of incidental or consequential damages,so that the above may not apply
to you.
Disclaimer of Warranties
This warranty contains the entire warranty and shall be in lieu of any
and all other warranties, whether expressed or implied (including all
implied warranties of merchantability or fitness for a particular pur-
pose) And of all other obligations or liabilities on the part of Digital
Security Controls Digital Security Controls neither assumes respons-
ibility for, nor authorizes any other person purporting to act on its
behalf to modify or to change this warranty, nor to assume for it any
other warranty or liability concerning this product.
This disclaimer of warranties and limited warranty are governed by the
laws of the province of Ontario, Canada.
DigitalSecurityControlsrecommendsthat the entire systembe completelytested
on a regularbasis. However,despite frequent testing, and due to, but not limited
to, criminaltampering or electrical disruption, it is possible for thisproduct to failto
performas expected.
Installer’s Lockout
Anyproductsreturned to DSC which have the Installer’sLockout option enabled
and exhibit no otherproblemswillbe subject to a service charge.
Out of Warranty Repairs
DigitalSecurityControlswillat itsoption repairorreplace out-of-warrantyproducts
which are returned to its factory according to the following conditions. Anyone
returning goodsto DigitalSecurityControlsmustfirst obtain an authorization num-
ber. Digital Security Controlswill not accept any shipment whatsoeverfor which
priorauthorization hasnot been obtained.
Products which Digital Security Controls determines to be repairable will be
repaired and returned. A set fee which Digital Security Controls has pre-
determined and which maybe revised fromtime to time, willbe charged for each
unitrepaired.
Productswhich Digital Security Controls determines not to be repairable will be
replaced by the nearest equivalent product available at that time. The current
market price of the replacement product willbe charged foreach replacement
unit.
27
To Next Page
Loading...
