21
RECEIVER DIAGNOSTIC TESTING
[901] Diagnostic Test Transmission
[3] Cellular 1 (OFF).
[4] Cellular 2 (OFF).
[5],[6],[7],[8] Reserved (OFF).
Use this section to force the Communicator to send an immediate test transmission to specific
receivers, to verify that the communications paths are available. Diagnostic Test Transmission
failure indicates as FTC trouble (Yellow LED = 9 flashes). If an FTC error occurs when testing
all receivers, select only one receiver and repeat test to isolate the receiver that is not
communicating.
SYSTEM INFORMATION (READ ONLY)
NOTE: Sections [987] - [998] are provided for information (Read Only). Values in these
sections cannot be modified by the Installer.
[987] Language Version
This section displays the current Language version of the Communicator.
[988] DNS 1 IP Address
This section displays the IP address of DNS Server 1. This is useful when the unit is
configured for DHCP and you need to see the IP address was assigned to the device by the
DHCP Server. This value is assigned by DHCP.
[989] DNS 2 IP Address
This section displays the IP address of DNS Server 2. This is useful when the unit is
configured for DHCP and you need to see the IP address that was assigned to the device by the
DHCP Server. This value is assigned by DHCP.
[990] Boot Loader Version
This section displays the current Boot Loader version of the Communicator.
[991] Firmware Version
This section displays the current firmware version of the device. Update worksheets with new
version after a flash update is completed.
[994] Cellular IP Address
This section displays the current dynamic IP address assigned by DHCP to the Cellular
connection.
NOTE: Cellular uses DHCP (Dynamic IP) only. The Cellular IP address is always provided
by the Cellular network (i.e., not programmable).
[995] SIM Number
This section displays the Subscriber Identity Module (SIM) number of the SIM card installed
in the Communicator. Format is: Major Industry Identifier (2 digits) Mobile Country Code (2
or 3 digits); Mobile Network Code (2 - 3 digits); Unique Number (10 - 12 digits); and
Checksum (1 digit). Valid SIM numbers range is: 18 - 21 numbers. This number is printed on
SIM and the outside of the Communicator carton.
NOTE: The Checksum digit is omitted on 19-digit SIM Card numbers.
[996] Cellular Telephone Number
NOTE: This section displays the Cellular telephone number of the SIM. This telephone
number is required by the Installer for DLS and remote firmware (flash) update. User
can access this telephone number by entering [*] [6] < > SMS Programming [*] and
select Phone No. 1 to display the phone number.
[997] IMEI Number
This section displays the unique 15-digit International Mobile Equipment Identity (IMEI) of
the radio. Format is: Reporting Body Identifier (2 digits), Allocation Number (4 digits); Final
Assembly Code (2 digits); Serial Number (6 digits); and a check digit.
To Next Page
Loading...
Need help?
General
