14
PRINTER SET-UP
The PC2585 software is capable of sending data to a local printer. The printer must be capable of serial (RS-232)
communication. The PC2585 should work with most serial printers, however the printers on the following list are
strongly recommended:
Compatible Printers
1 Brother M-1109
2 Brother M-1809
3 Star DP 40
4 Epson EP 40
5 C - Itoh model 8510 B
6 Citizen 120-D with serial card
7 Citizen 180-D with serial card
8 Roland DG PR 1112 with serial card
9 Panasonic KX P1091 I with serial card
10 Mannesman Tally MT81 with serial card
11 Raven 9101 with serial card
Configuring the Printer
1 Serial interface
2 Baud rate = 1200 (other baud rates may be used but Section [49] must be changed accordingly)
3 Parity = None
4 Character length = 8 bits
5 Auto line feed = Off
6 American/Canadian character set
To hook up the printer, start by fully powering down the panel and the printer. Using A DB-25 connector, connect the
printer to the panel as shown below. The maximum cable length should be 6 feet.
NOTE: If SRTS is not available, turn ON Zone Light 6 in Section [49] and attach yellow to 4 (RTS) or 20 (DTR).
1
4
3
11
7
20
BLK
BLK RED GRN YEL
RED
GRN
YEL
RTS
DTR
SRTS
QUAD CABLE
6ft (1.8 m) MAX.
PO2 AUX-
KEYPAD
RED
AUX IN
4700Ω
To Next Page
Loading...
