DSC PC2585 - [19] System Times; [20] First System Option Code

24
[21] Second System Option Code
Refer to Programming Section [20] for programming instructions.
Zone Light 1 • OFF = Telephone Line Monitoring (TLM) enabled
ON = TLM disabled
Zone Light 2 • OFF = TLM trouble emits keypad beeps only
ON = TLM trouble sounds bell while armed
Zone Light 3 • OFF = Restorals follow zones
ON = Restorals sent on bell time-out: if the zone is restored the restoral will not be sent until the
bell times out.
Zone Light 4 • OFF = Swinger shutdown resets on arming
ON = Swinger shutdown resets at midnight
Zone Light 5 OFF = Bell shutdown disabled
• ON = Bell shutdown enabled: if a zone is in swinger shutdown, the bell will not be reinitiated with
activity on this zone until swinger is reset.
Zone Light 6 • OFF = Bell output follows zone type
ON = Bell output is always pulsed
Zone Light 7 • OFF = Bell output normal
ON = Bell output inverted
If Zone Light 7 is ON: when a Bell Trouble occurs, the bell or siren will sound, but the trouble
will not be indicated on the keypad or transmitted to the monitoring station
Zone Light 8 • OFF = User DLS window disabled
ON = User DLS window enabled. Downloading must be enabled; pressing and holding the [9]
key for about 3 seconds will make the system wait 60 minutes for computer to call. Calls
received after the 60 minute time will not be answered.
• = Default setting
[22] Third System Option Code
Refer to Programming Section [20] for programming instructions.
Zone Light 1 • OFF = PO3 as Strobe Output
Refer to Section [31] for Output Option descriptions.
ON = PO3 as FTC Output
Zone Light 2 • OFF = PO4 as System Status Output
ON = PO4 as TLM and Alarm Output
Zone Light 3 • OFF = Test Transmission according to time in Section [19] and [32]
ON = Hourly Test Transmission; every hour on the hour
Zone Light 4 • OFF = Normal Test Transmission
ON = Test Transmission every 15 minutes: only when armed
Zone Light 5 OFF = Bell sounds when an FTC trouble occurs
• ON = No audible bell when an FTC trouble occurs
Zone Light 6 OFF = Downloading Annunciation disabled
• ON = Downloading Annunciation enabled. When enabled, the keypad will beep eight times
every ten seconds after downloading has been completed, or after a failed attempt at
downloading. The downloading annunciation tone may be silenced by pressing any key
on the keypad.
Zone Light 7 OFF = ID Tone / Panel Answer Acknowledge disabled
• ON = ID Tone / Panel Answer Acknowledge enabled
Zone Light 8 • OFF = 1300Hz ID Tone / Panel Answer Acknowledge Tone
ON = 2100Hz ID Tone / Panel Answer Acknowledge Tone
• = Default setting