DSC PC2585 - Programming Worksheets

38
PROGRAMMING WORKSHEETS
PC2585 v 1.1R
NOTE: In Sections [01] through [17], do not enter data in Sections that are not used.
AFTER EXITING THE INSTALLER’S PROGRAMMING MODE, ARM AND THEN DISARM THE
SYSTEM TO RETURN THE ZONES AND THE [F], [A] AND [P] KEYS TO NORMAL OPERATION.
[01] First Telephone Number
Page 18
Enter [0] for the digit “0” (zero) in the telephone number. Enter [#] to end the telephone number entry.
When using Pulse Dialing, do not enter [Q] or [#] in the Telephone Numbers.
[02] First Account Code
Page 18
For 3-digit Account Codes, enter [0] for the last digit. Where “0” (zero) is required in the Account Code, enter
HEX A ([Q][1][Q]).
[03] Second Telephone Number
Page 18
[04] Second Account Code
Page 18
[05] Third Telephone Number
Page 18
[06] Third Account Code
Page 18
[07] Alarm Reporting Codes, Zones 1 - 8
Page 19
For single-digit reporting codes, enter [0] as the second digit. Enter [Q][1][Q] (hex A) to transmit a “0”
(zero).
Zone 1 Alarm
Zone 2 Alarm
Zone 3 Alarm
Zone 4 Alarm
Zone 5 Alarm
Zone 6 Alarm
Zone 7 Alarm
Zone 8 Alarm
[08] Restoral Reporting Codes, Zones 1 - 8
Page 20
Zone 1 Restoral
Zone 2 Restoral
Zone 3 Restoral
Zone 4 Restoral
Zone 5 Restoral
Zone 6 Restoral
Zone 7 Restoral
Zone 8 Restoral