DSC PC2585 - Page 43

39
[09] Tamper Alarm Reporting Codes, Zones 1 - 8
Page 20
Tamper Alarm 1
Tamper Alarm 2
Tamper Alarm 3
Tamper Alarm 4
Tamper Alarm 5
Tamper Alarm 6
Tamper Alarm 7 / Fire Alarm
Tamper Alarm 8
[10] Tamper Restoral Reporting Codes, Zones 1 - 8
Page 20
Tamper Restore 1
Tamper Restore 2
Tamper Restore 3
Tamper Restore 4
Tamper Restore 5
Tamper Restore 6
Tamper Restore 7 / Fire Restore
Tamper Restore 8
[11] Closing Reporting Codes, Access Codes 1 - 8
Page 20
Access Code 1 Closing
Access Code 2 Closing
Access Code 3 Closing
Access Code 4 Closing
Access Code 5 Closing
Access Code 6 Closing
Access Code 7 Closing
Access Code 8 Closing
Partial Closing Code
[12] Closing Reporting Codes, Access Codes 9 -16
Page 20
Access Code 9 Closing
Access Code 10 Closing
Access Code 11 Closing
Access Code 12 Closing
Access Code 13 Closing
Access Code 14 Closing
Access Code 15 Closing
Access Code 16 Closing
Auto-Arm Cancellation Code
PC2585 v 1.1R
NOTE: Tamper Alarms cannot be bypassed
with the [Q][1] command. Tamper Alarms will
only be bypassed while the Installer’s
Programming Mode is active. Reactivate the
Tamper Alarms by arming and then disarming
the system after exiting the Installer’s
Programming Mode.