DSC PC4020 - V3.3 User Manual

18
Section 3: System Administration
NOTE: To enter the [
*
][6] menu, you may need to enter an access
code that has the “System Master” or “Supervisor” option enabled.
3.1 Turning on Quick Arm
Keypad Command: [
*
][6][Access or Master Code][0][0]
This option will allow users to arm the system by entering [*] [0] at any
keypad, instead of entering an access code. To turn this feature on, perform
the following:
1. Press [
*
] [6] [access or master code].
2. Use the arrow keys (< >) to scroll to the Toggle Options menu. Press
[0] or [
*
].
3. Use the arrow keys (<>) to scroll to the “Quick Arm” display. To
change the Quick Arm setting, press [0] or [
*
].
4. To exit the menu, press [#].
3.2 Turning on Quick Exit
Keypad Command: [*][6][access or master code][0][1]
This option will allow a user to exit an armed system through a designated
entry/exit point by entering [*] [0] at a keypad. The system gives the user
2 minutes to exit the premises. Once the user has exited the premises, the
system will continue to be armed. This option must also be enabled in
order for the Exit function key to work.
1. Press [*] [6] [access or master code].
2. Use the arrow keys (<>) to scroll to the Toggle Options menu. Press
[0] or [
*
].
3. Use the arrow keys (<>) to scroll to the “Quick Exit” display. To
change the Quick Exit setting, press [1] or [
*
].
4. To exit the menu, press [#].
3.3 Controlling Automatic Arming
Daily Auto-arming
Keypad Command: [
*
][6][access or master code][2]
This option will allow the system to be automatically armed at the same
time each day. In order for this function to work, you must both enable
the Auto-Arm function, and program the Auto-Arm Time (follow the steps
below).
To enable auto-arming at the same time each day, perform the following:
1. Press [
*
] [6] [access or master code].
2. Use the arrow keys (<>) to scroll to the Auto-Arm Control menu.
Press [2] or [
*
].
3. Use the arrow keys (<>) to scroll to the “Auto Arm” display. To change
the Auto Arm setting, press [0] or [
*
].

DSC PC4020 - V3.3 Specifications

General

Partitions	8
Battery Backup	12 VDC, 7 Ah
Power Supply	16.5 VAC, 40VA
Outputs	4 programmable outputs
Compatibility	Compatible with DSC PowerSeries keypads and accessories
Keypads Supported	PC5508, PC5508Z, PC5516, PC5516Z, PC5132, PC5132RKZ, PC5164, PC5164RKZ