DSC PC4020 - V3.3 User Manual

27
Section 4: Access Control
4.5 Adding Tenant Codes for Users (PC4850 Modules)
You can give visitors the option of entering a 1-4 digit code on the keypad
to call a user. To do this, enter the 1-4 digit code for the apartment. If a
user knows a visitor is coming, they can give them the tenant code as a
faster way to call them. For this to work, the user’s telephone number
must also be programmed (see section 4.4).
NOTE: Tenant codes cannot begin with “0”.
1. Enter [
*
][5] followed by a Master code.
2. Locate the access code for the user with one of the code-searching
methods (see Section 2.2 “Modifying an Existing Code”). Press [
*
] to
select.
3. Use the right arrow (>) key to scroll to the following display:
Select (8) < >
Tenant Code
4. Press [8] or [
*
].
5. Enter up to 4 digits for the tenant code.
6. When you are finished, press [#].

DSC PC4020 - V3.3 Specifications

General

Partitions	8
Battery Backup	12 VDC, 7 Ah
Power Supply	16.5 VAC, 40VA
Outputs	4 programmable outputs
Compatibility	Compatible with DSC PowerSeries keypads and accessories
Keypads Supported	PC5508, PC5508Z, PC5516, PC5516Z, PC5132, PC5132RKZ, PC5164, PC5164RKZ