11
Section 2: Access Codes
Access codes are used to arm and disarm the system as well as to access
system functions. There are many different codes available on the system.
The
Grand System Master Code Grand System Master Code
Grand System Master Code Grand System Master Code
Grand System Master Code will be able to perform all system
functions. This includes zone bypassing, activating outputs enabling user
options and programming access codes. The Grand System Master Code
is access code 0001. Normally, only your installer can change this code.
Please ask your installer if you wish to be able to alter this code.
The following sections explain how to program new codes and modify
existing codes. All access code options will also be described.
2.1 Programming A New Access Code
This section describes the basic aspects to programming an access code:
• How to select a new access code for programming
• How to program the 4- or 6-digit code
• How to program the user’s name to identify the code
• How to select the partitions the code will be active on
To select a new access code for programming, perform the following steps:
1. Enter [
*
][5] followed by a Master Code.
2. The display will read:
Select (0) < >
User No. Search
Press [0] or [
*
].
3. The display will read:
Sel. Code (0001) < >
User 1
User 1 (Access Code 0001) is the System Master Code. Your installer
may already have programmed this code. Use the right arrow (>)
key to scroll to the code you wish to program (for example, access
code 0002). Press [
*
] to select the code.
4. The display will read:
Select (0) < >
Program Code
This is the
PrPr
PrPr
Pr
ogram Code menuogram Code menu
ogram Code menuogram Code menu
ogram Code menu. Use the right arrow (>) key to scroll
though each display in the Program Code menu. Each display
pertains to a different aspect of access code programming, including
the three listed below. To select any menu item for programming,
press [
*
].
To Next Page
Loading...
Need help?
General
