EasyManua.ls Logo

DSC TL2803GR - Programming Options

DSC TL2803GR
52 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
22
HSPA(3G) Alarm Communicator Installation Manual
[009] Language
Default (01)
NOTE: After programming this section, perform a ‘Default Language in section [999][11] to have
programmable labels available in the selected language. Programming this section with
an invalid language will default to English (01).
Programming Options
[010] System Toggle Options 3
[1] Reserved.
[2] Visual Verification. Default (OFF)
ON: Visual verification is enabled.
OFF: Visual verification is disabled.
[3] Reserved.
[4] Reserved.
[5] Reserved.
[6] Reserved.
[7] Reserved.
[8] Reserved.
[011] Installer Code
Default (CAFE)
Program the installer code for the communicator module. The installer code will be required when
programming the communicator module. Valid range: 0000 - FFFF.
[012] DLS Incoming Port
Default (0BF6/3062)
The DLS incoming local port (listening port) is the port DLS IV will use when connecting to the
communicator. If a router or gateway is used, it must be programmed with a transmission control
protocol (TCP) port forward for this port to the communicator module IP address. Valid range:
0000 - FFFF.
[013] DLS Outgoing Port
Default (0BFA/3066)
The DLS outgoing port is used for outgoing session to DLS IV after an SMS request has been sent
to the communicator. Use this section to set the value of the local outgoing port. The value must be
changed if the communicator is located behind a firewall and must be assigned a particular port
number, as determined by your network administrator. In most cases, changing the default value or
configuring your firewall with this port is not required.
Valid range: 0000-FFFF.
NOTE: If section [006] toggle option [7] is ON, DLS will use the primary path for the session. If
section [006] toggle option [7] is OFF, DLS will use the Ethernet path, if available.
Table 9: Programming Label Languages
OPT Language OPT Language OPT Language OPT Language
00 Reserved 05 Italian 10 German 15 Greek
01 English 06 Dutch 11 Swedish 16 Turkish
02 Spanish 07 Polish 12 Norwegian 17-99 Reserved
08 Portuguese 08 Czech 13 Danish
04 French 09 Finnish 14 Hebrew

Related product manuals