Need help?Do you have a question about the DSE DSE7420 and is the answer not in the manual?
Describes rear panel terminals for connections.
Provides common and alternative wiring configurations.
Describes the front panel controls of the DSE7410.
Describes the front panel controls of the DSE7420.
Overview of module control via push buttons.
Detailed explanation of each front panel button function.
Describes how to put the module into stop mode.
Details operation in manual mode.
Details operation in test mode.
Explains automatic generator operation.
Describes the waiting state in auto mode.
Details the automatic start sequence.
Explains engine running in automatic mode.
Describes the automatic stopping sequence.
Details the high current warning alarm.
Lists and explains shutdown conditions.
Lists and explains electrical trip conditions.
Details high current trip logic.
Details earth fault trip logic.
Details short circuit alarm logic.
How to enter the configuration editor.
Steps for editing parameters.
How to enter the editor while the engine is running.
Pre-start checks and system startup procedures.
Troubleshooting for starting issues.
Troubleshooting for engine not taking load.
Troubleshooting for various alarms.
Troubleshooting communication issues.
General| Model | DSE7420 |
|---|---|
| DC Supply | 8V to 35V continuous |
| Magnetic Input Frequency | 10, 000Hz (max) |
| Storage Temperature Range | -40 °C to +85 °C |
| Digital Inputs | 8 |
| Analog Inputs | 4 |
| Cranking Dropouts | Able to survive 0V for 50ms, providing supply was at least 10V before dropout and supply recovers to 5V |
| Alternator Input Frequency | 50 Hz - 60 Hz |
| Panel Cut-out | 220mm x 160mm |
| Inputs | Configurable |
| Outputs | Configurable |
| Voltage | 8-35V DC |
| Protection Rating | IP65 (front) |
| Communication Interface | RS232, RS485, USB |
To Next Page
