Need help?Do you have a question about the DSE 8610 MKII and is the answer not in the manual?
Explains the function and operation of each push button on the module's front panel.
Explains how to enter Stop/Reset mode and its implications for generator operation.
Details manual operation, including starting sequences and engine running.
Describes automatic operation, including starting, running, and stopping sequences.
Explains the benefits, requirements, and operation of dead bus synchronising.
Describes the alarm system, including types, causes, and display.
Details warning alarms that draw operator attention to undesirable conditions.
Describes electrical trip alarms that stop the generator in a controlled manner.
Details shutdown alarms that immediately stop the generator to prevent damage.
Covers the over current alarm, including immediate warnings and IDMT curves.
Details the short circuit IDMT alarm and its application for thermal protection.
Explains the earth fault IDMT alarm for detecting earth fault currents.
Guides on accessing, entering PIN, editing, and exiting the main configuration editor.
Details accessing and editing parameters while the generator is running.
Details the four essential steps for achieving successful synchronisation.
Troubleshooting guide for starting issues, symptoms, and possible remedies.
Troubleshooting guide for loading issues, symptoms, and possible remedies.
Troubleshooting guide for alarm issues, symptoms, and possible remedies.
General| Generator & Mains Frequency | 3.5 Hz to 75 Hz |
|---|---|
| Display | LCD with backlight |
| Communication | RS232, RS485, Ethernet, USB |
| Inputs | 4 analogue inputs |
| Outputs | Configurable x 8 |
| Power Supply | 8 to 35 V DC |
| Operating Temperature | +70°C |
| Dimensions | 240mm x 181mm x 42mm |
| Magnetic Pick-up Voltage Range | 0.5 V |
| Magnetic Pick-up Frequency | 10, 000 Hz (max) |
| Protection Rating | IP65 (Front only) |
To Next Page
