To Next PageTo Next Page
Need help?Do you have a question about the DSE 4110 and is the answer not in the manual?
How to activate auto mode, start sequence, and engine start process.
Steps to initiate a start sequence in manual mode and engine running behavior.
Procedure for setting up a 30-minute test run every seven days for the generator.
Warning types used to alert the operator of impending faults.
Shutdown conditions that latch and stop the generator, requiring fault clearance.
Method to enter configuration mode using a switch on the rear of the PCB.
Steps for selecting and changing parameters using the module's pushbuttons.
Configurable timer for pre-heating the engine prior to cranking.
Delay for activating remote start or mains failure before starting the engine.
Delay for deactivating remote start before stopping the engine.
Timer controlling the engine stop solenoid after the engine stops.
Delay for engine warm-up before load transfer.
Delay for engine cool-down before stopping after load transfer.
Configurable setting for the system's nominal operating frequency (50 Hz or 60 Hz).
Configurable setting for the generator battery voltage (12V or 24V).
Configuration for the oil pressure switch behavior on fault.
Configuration for the coolant temperature switch behavior on fault.
Option to disconnect the starter motor upon oil pressure detection.
Enables automatic shutdown if generator frequency falls below a set threshold.
Configurable functions for Auxiliary Input 1, including warning or shutdown types.
Configurable functions for Auxiliary Input 2, including warning or shutdown types.
Configurable functions for Auxiliary Output 1, such as pre-heat or load transfer.
Configurable functions for Auxiliary Output 2, such as pre-heat or load transfer.
Specifies the required panel cutout dimensions for module installation.
Guidelines for operating temperature range and ventilation requirements for the module.
Provides overall physical dimensions and mounting details of the unit.
Illustrates and describes the layout of the front panel controls and indicators.
Illustrates and describes the layout of the rear panel connections and markings.
Details pin assignments, descriptions, cable sizes, and notes for rear connections.
Comprehensive explanation of the function of each pin on the module's connectors.
Essential pre-start checks and initial system tests before full operation.
Explanation of the advantages and functionality of DSE's solid-state outputs.
Description of the functions associated with each push button on the module.
Details the display icons and their corresponding alarm or shutdown conditions.
General| Model | DSE 4110 |
|---|---|
| Magnetic Input Frequency | 10, 000 Hz (max) |
| Storage Temperature Range | -40 °C to +85 °C |
| Input Voltage Range | 8 V to 35 V |
| Cranking Dropouts | Able to survive 0 V for 50 ms |
| Maximum Operating Current | 96 mA at 24 V |
| Alternator Input Frequency | 50 Hz to 60 Hz |
| Display Type | LCD |
| DC Supply | 12/24 V DC |
| Magnetic Input Range | 0.5 V to 70 V RMS |
