Need help?Do you have a question about the DSE DSE704 and is the answer not in the manual?
Describes how to start the engine manually, including pre-heat, starter motor engagement, and shutdown conditions.
Explains automatic start sequences triggered by mains failure or remote start, covering start delays and load transfer.
Details warning conditions that alert the operator to potential issues, such as battery charge failure.
Covers critical fault conditions that cause the generator to stop, like fail to start, low oil pressure, and overspeed.
Illustrates how solid state outputs are wired, typically to drive a fuel solenoid through an automotive relay.
General| Model | DSE704 |
|---|---|
| Type | Manual Engine Control Module |
| Operating Temperature Range | -30°C to +70°C |
| Alternator Input Frequency | 50Hz - 60Hz |
| Magnetic Input Range | 0.5-5V AC |
| Panel Cut-out | 68mm x 68mm |
| Protection Rating | IP65 (Front only when installed into the panel with sealing gasket) |
| DC Supply | 8-35V DC |
To Next Page
