DSE Model 4110 AutoStart Operators Manual
4 057-022 4110 OPERATING MANUAL ISSUE 5.1 18/06/2007 JR
1 INTRODUCTION
The DSE 4110 automatic start module has been primarily designed to allow the user to start and stop the
generator, transferring the load automatically to the generator. If required the generator can be started and
stopped manually.
The DSE 4110 module has a built in LCD hours counter, which displays the number of hours that the generator
has run, to the nearest 1/10 hour.
The DSE 4110 module monitors the engine, utilising 8 LEDs to indicate fault conditions. When a fault is detected
the generator is automatically shut down, giving a true first up fault condition.
The customer, using the module’s front panel configuration editor, can alter selective operational sequences,
timers and alarm trips.
The module is housed in a fully enclosed robust plastic case for front panel mounting, offering a high rating of IP56
with the optional gasket. Connections to the module are via locking plug and sockets.
2 CLARIFICATION OF NOTATION USED WITHIN THIS PUBLICATION.
NOTE:
Highlights an essential element of a procedure to ensure correctness.
CAUTION!
Indicates a procedure or practice which, if not strictly observed, could result
in damage or destruction of equipment.
WARNING!
Indicates a procedure or practice, which could result in injury to personnel
or loss of life if not followed correctly.
©
Deep Sea Electronics Plc owns the copyright to this manual, which cannot
be copied, reproduced or disclosed to a third party without prior written
permission.
Compliant with BS EN 60950 Low Voltage Directive
Compliant with BS EN 50081-2 EMC Directive
Compliant with BS EN 50082-2 EMC Directive
UL Registered Component for USA & Canada
To Next Page
Loading...
