menu - Tyre calibration
This function allows the user to run the procedure for
calibrating and teaching in the tyre rolling
circumference or to restore their original values. It
also allows you to correctly learn the final drive ratio
(front sprocket/rear sprocket) in the event of
modifications to the approved configuration. Refer
to the table of front sprocket/rear
sprocket combinations for this model, if any.
Then the Tyre Calibration function:
●
if tyres must be replaced
●
if final drive ratio must be changed
To open this function:
●
From the Interactive Menu, use (1) and
(2) to select the item menu" and press
ENTER (3).
●
Select the “Tyre calibration” item and press
ENTER (3).
If a tyre calibration has never been carried out,
is displayed.
If a calibration has already been carried out,
“Default” is displayed instead of
Fig 189
Fig 190
221
To Next Page
Loading...
Need help?
General
