E
51
Turn indicators (fig. 49)
Remove the screw (1) and detach the glass (2) from the
indicator body holder.
The bulb is of the banjo-type: press and rotate
anticlockwise to remove. Fit the spare bulb by pressing
and turning clockwise until it clicks. Refit the glass sliding
the small tab (A) into the suitable slot in the indicator body
and tighten the screw (1).
Brake light (fig. 50)
To replace the stop and parking light bulb, unscrew the
two screws (1) that secure the glass (2) and remove glass.
The bulb is of the banjo-type: press and rotate
anticlockwise to remove. Fit the spare bulb by pressing
and turning clockwise until it clicks. Refit the glass.
Number plate light (fig. 50)
Working from inside, remove the bulb holder to gain
access to the number plate lamp (3), then remove the bulb
and replace it.
2
1
3
fig. 50
2
A
1
fig. 49
ProCarManuals.com
To Next Page
Loading...
