Caution
Dispose of used cartridge. Do not reuse cartridges.
Grease the seal with engine oil and then fit the new cartridge (4).
Note
If you wish to skip this last check, fill the filter cartridge (2) with oil before installation and you will not need to top up
level later.
Screw it in its seat and tighten to the specified torque (Sect. C 3, Engine torque settings).
Clean the oil mesh filter every second oil change.
Unscrew the outer plug (5).
Release and withdraw the mesh filter (7).
Clean the mesh filter with gasoline and compressed air. Care must be taken not to break the filter mesh.
Refit the mesh filter (7) and its seal (6) on the plug (5) and tighten to the specified torque (Sect. C 3,
Engine torque
settings).
file:///C|/Documents%20and%20Settings/F4i/My...anual/wsm/usa/Mon695_MY07_D_4_5_00.18.1.html (2 of 29) [10/7/2008 8:42:49 PM]
To Next Page
