Refitting the starter motor driven gear
Installation is a reversal of the removal procedure.
Note
Apply recommended threadlocker to screw (26), then tighten it to the specified torque (Sect. C 3, Engine torque
settings).
Operations Reference See Section
Refit the generator flywheel unit N 8,
Flywheel - generator
file:///C|/Documents%20and%20Settings/F4i/My...anual/wsm/usa/Mon695_MY07_N_9A9_00.73.1.html (10 of 10) [10/7/2008 8:46:24 PM]
To Next Page
