Ducati MONSTER 695 - Refitting the starter motor; Starter contactor

Electric starting
Note
Starter motor retaining screws are originally assembled with threadlocker.
Slide out starter motor and gasket (2).
Refitting the starter motor
Visually inspect gasket (2) for wear. Replace if necessary.
Place gasket (2) and starter motor on casing and tighten screws (1) to the specified torque (Sect. C 3,
Frame torque settings).
Connect starter motor / starter contactor cable (3).
Caution
Fill the protective cap with protective grease before fitting it on the starter motor.
If the starting gears assembly was replaced, refit starter motor intermediate gear and timing
intermediate gears (Sect. N 9.1, Refitting the starter motor driven gear).
Close the generator cover (Sect. N 8,
Reassembling generator cover).
Starter contactor
file:///C|/Documents%20and%20Settings/F4i/My%...manual/wsm/usa/Mon695_MY07_P_3_9_00.80.1.html (4 of 6) [10/7/2008 8:47:02 PM]