Connect a common brake bleeder, easily available on the market, to the caliper bleed valve (2- front) or (4 -rear).
Note
If you are using a commercial bleeder, follow the manufacturer's instructions.
Unscrew the bleed valve and pump the bleeder until all the fluid has fully drained off the circuit.
If you do not have a brake bleeder available, attach a length of transparent plastic tubing to the caliper bleed valve (2
-front) or (4 -rear) and put the other end of the hose into a container holding spent brake fluid you will have placed
on the floor.
Unscrew the bleed valve by one fourth of a turn.
Operate the brake lever (or pedal) until all the fluid has fully drained off the circuit.
Repeat this operation for each brake caliper.
Filling the brake circuit
file:///C|/Documents%20and%20Settings/F4i/My...anual/wsm/usa/Mon695_MY07_D_4_5_00.18.1.html (10 of 29) [10/7/2008 8:42:49 PM]
To Next Page
