Open the bleed valve (3) by one fourth of a turn and operate the clutch lever several times until the fluid starts
coming out of the bleed valve (3).
Pull the lever fully in and slacken the bleed valve by at least one fourth of a turn.
Allow several seconds and then release the lever gradually and close the bleed valve (3).
Caution
Do not release the clutch lever until the bleed valve has been fully tightened.
Repeat the bleeding operation until air bubbles no longer come out of the plastic tube.
Tighten the bleed valve (3) to the specified torque (Sect. C 3,
Frame torque settings). Fit the protection cap.
Top up the clutch fluid up to 3 mm above the MIN mark.
Refit the diaphragm and cap (1) to reservoir (A), tighten the screws (2).
Adjusting steering bearings play
file:///C|/Documents%20and%20Settings/F4i/My...anual/wsm/usa/Mon695_MY07_D_4_5_00.18.1.html (19 of 29) [10/7/2008 8:42:49 PM]
To Next Page
Loading...
