If the operation is performed, the message "Was the operation successful?" is displayed; press "Confirm" (D).
If there are problems in performing the operation, the relevant error messages are displayed: you need to confirm or
reject each message by pressing "Confirm" (D) or "Exit" (E), respectively.
The zero setting procedure establishes a connection between electronic control unit and throttle body. For this reason,
the zero setting procedure must be repeated each time the throttle body, throttle position sensor, electronic control
unit or wiring are replaced.
Adjusting idling condition
Connect exhaust gas analyser inserts part no. 88713.1010 to exhaust pipes pick-up points, using couplings (20).
file:///C|/Documents%20and%20Settings/F4i/My...anual/wsm/usa/Mon695_MY07_D_5_5_00.19.1.html (16 of 41) [10/7/2008 8:43:05 PM]
To Next Page
Loading...
